Burning the print head is the most troublesome problem in the process of using the printer. Once the burning print head appears, it not only increases the cost, but also affects the printing efficiency. So now let's understand what are the reasons for the burning!
 
1. Voltage and current overload. This kind of situation mostly occurs in the peak period of electricity consumption, especially in summer, please be sure to install a 5000W voltage regulator to prevent it from happening.
 
2. Ground wire. The main purpose of grounding is to prevent the accumulation of static electricity in the fabric printer. Once excessive static electricity is difficult to discharge from the machine, it will cause problems such as burning printheads and board cards.
 
3. Switch on and off frequently. The current at the moment of start-up has an impact on the fedar fabric printer. Frequent switching on and off will only increase the burden on the printhead and even burn it. The recommended interval is five minutes.
 
4. The printhead data cable is short-circuited. The data line of the print head is used for a long time, causing a short circuit; when the data line of the print head is replaced, it is not inserted flat, so that the core of the wire is curled, causing a short circuit; dripping ink onto the data line of the print head, causing a short circuit.
 
5. High temperature. The main performance is: long time overload operation or room temperature is too high, it is recommended to shut down and repair or turn on the air conditioner to reduce the temperature.
 
6.The board has ink. The ink used in the outdoor printing machine has a certain degree of corrosion. Dropping on the board will not only cause corrosion, but also cause short circuit and other problems, causing burn-in problems.
 
7. Ink tube has air. The air bubbles in the ink tube are the culprits that cause the printhead to burn. Therefore, it is very important to master the correct ink application skills. Check the amount of ink before starting the machine every day.