The inkjet t shirt printer needs to pay attention to maintenance in daily use, effectively extend the service life and create greater profits. The following are the problems encountered in daily use of the inkjet t shirt printer. Fedar printer group summarizes for your reference.
 
1. The car cover should be used when printing to prevent the ink from contaminating the nozzle, connection port, nozzle color separation plate, etc., otherwise, it is easy to cause a short circuit accident and damage the nozzle.
 
2. When operating the inkjet printer control panel or nozzle, be sure to cut off the power first and take anti-static measures.
 
3. If the inking speed is slow, the filter must be checked or replaced.
 
4. When the inkjet t shirt printer’s software is in use, other programs cannot be opened, nor can two programs be opened.
 
5. The noise of the car is increased, and the wear of the slider or the head and tailstock bearings should be checked.
 
6. The parameter settings of the computer system cannot be changed, especially when reinstalling the system to ensure that the settings are accurate.
 
7. The data transmission cables in the towline must be checked for wear regularly to ensure that there is no open circuit, short circuit and signal interference.
 
8. If the canvas is too large to move, it will bring horizontal stripes to the screen, and it will also make the canvas move inaccurate. You can open the canvas to make the cloth evenly distributed.
 
9. The parameters of the vertical step distance are adjusted in the driver software, and the adjustment method is shown in the software instructions.
 
10.Cannot transfer files to the controlling computer during printing.
 
11. Do not push the car when the motor is energized, otherwise, various dislocations will easily occur.
 
12. The parameters of the drive have been adjusted before leaving the factory, and the user cannot modify it without authorization. If the motor fails during use, please observe the motor alarm signal in detail, and the professional should refer to the manual for handling.
 
13. The tension of the timing belt should be appropriate, too tight or too loose will not work, adjust with adjusting bolts.
 
14. Each pipe interface of the ink supply system must ensure that there is no leakage. Check whether the ink supply of the ink cartridge is normal, and ensure that there is no air leakage at the ink supply tube interface of the nozzle, and there are no ink bubbles in the ink supply tube, otherwise insufficient ink supply will occur.
 
15. The printed files in the computer system should be cleaned up at any time to ensure that the hard disk has enough space.
 
16. The ink should be supplied before the nozzle is powered on, because ink is the main way to take away the heat of the nozzle.
 
17. The inkjet t shirt printer is sensitive to static electricity, and the ground wire should be handled under the guidance of the installer.