What are the reasons for the problem of the paper feeding system of fedar heat transfer printer? Fedar heat transfer printer manufacturers will help you out.
 
Reasons for the failure of the paper feeding system of fedar heat transfer printer:
1. Fedar heat transfer printer is not loaded with printing paper;
2. The plug of the connecting line between the paper feeding system of fedar heat transfer printer and the main board is not connected properly;
3. The retractable function of the main board of fedar heat transfer printer is incomplete;
 
Solutions to the above failure causes:
1. Load paper and test;
2. Check whether each connection port of the paper feeding system of fedar heat transfer printer is normal;
3. Replace the main board of fedar heat transfer printer with normal retractable paper system;
 
Of course, there are other malfunctions: if fedar heat transfer printer keep feeding paper, the probe is broken. Replace the upper and lower probes of fedar printer. If it happens occasionally, it is the cause of static electricity. Check the ground wire.
 
How to put the paper in fedar heat transfer printer?
 
Put the paper on the paper bar, then fix the two ends, put it on the paper tray, and block the detection head with something. At this time, you can pull out some paper and place it on the paper feeder. At this time, press the paper on it with your hand. , With the other hand, shake the paper tube below, mainly to shake the paper straight and flat, in a vertical relationship with fedar heat transfer printer. Then jam the paper on both sides, expose the detection head, and then push it along the fixed position of the paper. At this time, the paper is still perpendicular to fedar heat transfer printer, and then fedar printer pushes the paper so that it will not bend.
 
Want to know more about the operation and maintenance knowledge of fedar heat transfer printer, please pay attention to the official website (www.fedar.net), we will provide the most useful information.