The failure of the heat transfer printer is inevitable, and some common failures are commonplace, and user already knows how to solve them. However, some special faults of the heat transfer printer are not common and do not know how to solve them. Fedar heat transfer printer factory summarized several special fault solutions for everyone.
 
1. Clicking the "Maintop Print" button does not respond. When this happens, many people think that it is a problem of the heat transfer printer, which is actually caused by your printing software. This phenomenon should be solved as follows:
 
① Too many print tasks cause the cache to be unable to accept new tasks, so clicking print does not respond, the best solution is to restart the computer or clear the buffer;
 
②The port setting is wrong, the interface does not correspond to the recognition, so click on the print no response, the best solution: set the port correctly.
 
2. If the printer screen is fuzzy. That's usually because the print head prints too much, just use cleaning liquid to clean it, and it becomes clear immediately. If the resolution is still not high, it may be that the position of the print head is deviated during cleaning, and you only need to adjust the correct position.
 
3. The color misregistration is the difference between the printed color and the color in the computer. The main reason for this phenomenon is that the software is not set properly or the printer driver version is too low. There is also a calibration problem. The display is consistent with the actual printing effect. Different printing software has different calibration methods, you can open the printer options to set.