1.Cleaning fedar heat transfer printer head
①To clean fedar heat transfer printer head, distilled water, a lint-free scrub cloth and a plate are needed. Each printer head must be cleaned with clean water. In addition, an ultrasonic cleaner can also be used to clean fedar heat transfer printer head.
 
②Soak the cloth with distilled water. Use a damp cloth to gently suck (do not wipe)the nozzle at the bottom of fedar heat transfer printer head 3 to 5 times. Repeat this process for each nozzle, ensuring that each nozzle is scrubbed with a clean part of a cloth or a clean cotton swab to avoid mixing the colors of the nozzles. Test fedar heat transfer printer head to see if it is blocked. If there is a blockage, heat the distilled water slightly and place a small amount on the plate. (When placing fedar heat transfer printer head on the plate, the water surface should not be higher than 2 cm from the bottom because water may leak behind the chip.)
 
③Stand fedar heat transfer printer head upright in warm water. Wait for 30 seconds, and then test after drying it.
 
2. Fedar heat transfer printer chip cleaning
You need to use alcohol and cotton swabs or a lint-free scrubbing cloth to clean the chip. Turn off the power of fedar heat transfer printer first. Then soak the cloth or cotton cloth with wine, gently scrub the wicks behind fedar printer head, and wipe off the dirt or ink.
 
3.fedar heat transfer printer trolley frame cleaning
Take fedar heat transfer printer head out of the trolley frame, and gently scrub the contact strip on the trolley frame with a clean wet cotton swab or damp cotton cloth. After cleaning, install fedar printer to make sure they are properly installed in place.