For users of fedar inkjet t shirt printer,damper is not unfamiliar. As an important accessory of fedar printer, damper sometimes directly affect the quality of printing. However, how should damper be replaced?
 
Fedar inkjet t shirt printer damper is located above printhead, in a semi-transparent state, there is a half bag of ink and a filter net inside. The filter net is mainly used to filter impurities brought by the ink and reduce the probability of nozzle blockage. After using fedar inkjet t shirt printer for a long time, you will observe that there are too many impurities in damper.If fedar inkjet t shirt printer damper is clogged, and nozzle missing occur when printing pictures. For such minor faults, fedar printer manufacturer generally recommends replacing damper.
 
Some users may have questions: How to clean damper instead of replacing it? As a manufacturer of inkjet t shirt printer, fedar printer still recommend that you replace them instead of cleaning them! The method provided on the Internet: you can shut down the printer, determine whether it is damper or printhead in turn, and then prepare a screwdriver, syringe, disposable cup, paper towel, etc. to clean the removed damper. Note that if you are unfamiliar with this, don't try it lightly. If you don't operate properly, you may lose a lot of money. Fedar inkjet t shirt printer damper is not expensive (it is recommended to use damper recommended by the manufacturer or the original damper of the manufacturer for better results).
 
Fedar inkjet t shirt printer knowledge class:
Question: Why does fedar inkjet t shirt printer start the trolley and move to the left end and report an error?
Reasons: 1. The paper tester is broken 2. The trolley board and the paper tester are not connected well
Solution: (1) Change the paper tester (2) Align the line of the paper tester with the interface of the trolley board and then plug it tightly.